High-speed rotary cutting line, GM series

Box & Papers:

• Feed section

  Feed section

   Description:

  • The machine is equipped with an alarm bell, and during movement the bell rings continuously, ensuring the safety of workers.
  • The drive shaft is equipped with a friction clutch, which prevents accidental activation and damage to the machine.
  • Pneumatic blocking device.
  • Frequency drive as the main one, frequency conversion control system, energy saving, stable start and engine start protection device.
• Roller feed system on the leading edge

  Roller feed system on the leading edge

   Description:

  • Vacuum auxiliary supply system, 7,5 kW fan, air volume adjustment to ensure smooth supply.
  • The cutting section is equipped with a chain switch for the possibility of an emergency stop of the feed.
  • Roller feed system along the leading edge.
  • Positioning of the side and rear reflector are regulated electrically; the gap on the front reflector is adjusted manually.
  • The system of filing with separate sheets (if necessary, you can choose continuous or sheet-by-sheet filing).
• Cutting section

  Cutting section

   Description:

  • The supporting and die-bearing shafts are made of high-quality steel, the surface is polished and chrome-plated.
  • Balancing correction, increased stability of work.
  • The stamp bearing shaft and the rubber roller can be automatically disconnected, reducing the load and extending the life of the stamp.
  • The feeding system is an automatic lifting device with a pneumatic roller.
  • The rubber roller can move horizontally by 40 mm with the help of mechanics, so the average wear distribution of the rubber roller can significantly increase its service life.
  • Mechanical speed compensation device. Regardless of how the diameter of the rubber gasket changes, the speed compensation device can provide excellent sliding of the rubber roller with the help of a stamp-bearing shaft, so that the surface speed of the rubber pad is completely controlled by the stamp.
  • Electronic digital system for adjusting the phase of the die-bearing shaft.
  • The phase adjustment module, the structure of the planetary transmission.
  • The cutting phase has a 360-degree electronic digital adjustment that can be controlled by running, stopping and reversing.
  • The machine is equipped with a system for adjusting the supply of glue, which can be used after multiple adjustments of the rubber roller.
• Mechanical part

  Mechanical part

   Description:

  • All shafts are chrome-plated and polished.
  • All gears undergo heat treatment and are made of high-quality 45# carbon steel produced by Shansa Datong Armaments Department. The gearbox uses a keyless compensating seam to reduce center wear and accurate alignment. Transmission structure - without backlash.
  • Automatic lubrication system. Oil tanks are made of thick iron plates, which excludes oil leakage.
  • All bearings are from the Chinese national manufacturer of high-quality products - Harbin Bearing.
  • The walls of the machine undergo heat treatment and are made of malleable cast iron. Thickness: 40 mm, they have good damping properties and do not deform. 
• Electrical part

  Electrical part

   Description:

  • All electrical equipment is from the well-known Chinese manufacturer Zhejiang Zhengtai Electric Appliance.
  • The main drive engine is from Hebei Hengshui. Stepless speed regulation, stable operation in energy saving mode and operation at low speed.
  • When starting, a signal bell is sounded, ensuring the safety of the operator.